To modify the ActiveX control properties and position,
you need to activate the design mode. When the design mode is not active,
the ActiveX control appears static and locked.
The current mode is identifiable through the small Design
Mode icon
on the control tool box.
If this icon appears sunken, you are working under the Design Mode.
Before you start, make sure that the control tool box appears.
From the , select . On the pop-up sub-menu, make sure that the Control Toolbox is checked. If it is unchecked, check the option. The Design Mode icon appears at the top left of the Control Tool-box.
If the Design Mode icon is sunken, you are already under the Design Mode.
Otherwise, click on the
icon on the control tool box.